The Phatty or Skinny Hind Skid can be placed on front or rear Axles or both!  Made from either 3D print/Delrin/Brass, these Hind skids replace your diff cover and provide 39° of sliding angle compared to the 90° stock diff cover.

The Skinny Brass Hind was made in mind to use on the front axle for great weight bias. It has 22 grams of weight, so this means you could remove your brass wheel rings and get lighter rotational weight in your wheels(Better acceleration and deceleration) while still having good unsprung weight up front. Then have the Phatty Hind in the rear for maximum deflection. But its your rig, run both brass. both Skinnies, both Phattys or both Delrin or mix it up to your needs!

Comes with bearing preinstlled and hardware.

If not using a link riser, some modification will be necessary for the upper links to not hit but not always the  case. 

Weight - Phatty 3D - 7 grams

               Phattty CNC Delrin - 9 grams

               Skinny 3D - 3 grams

               Skinny CNC Delrin - 3.7grams

              Skinny Brass - 22 grams

Dont get your rear end hung up on your lines, keep the Flow!